P3602ACMC datasheet(82/212 Pages) TECCOR

82 / 212 page

CATV Line Amplifiers/Power Inserters SIDACtor Device

http://www.teccor.com

2 - 64

+1 972-580-7777

SIDACtor® Data Book and Design Guide

CATV Line Amplifiers/Power Inserters

SIDACtor Device

This SIDACtor device is a 5000 A solid state protection device offered in a non-isolated

TO-218 package. It protects equipment located in the severe surge environment of CATV

(Community Antenna TV) applications.

In CATV line amplifiers and power inserters, this device can replace the gas tubes

traditionally used for station protection because SIDACtor devices have much tighter

voltage tolerances.

* For surge ratings, see table below.

** IT is a free air rating; heat sink IT rating is 25 A.

General Notes:

• All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.

• IPP is a repetitive surge rating and is guaranteed for the life of the product.

• Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.

• VDRM is measured at IDRM.

• VS is measured at 100 V/µs.

• Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.

• Off-state capacitance is measured at 1 MHz with a 2 V bias and is a typical value.

Electrical Parameters

Part

Number *

VDRM

Volts

IDRM

µAmps

mAmps

Amps **

mAmps

P1900ME

140

220

800

2.2/25

750

P2300ME

180

260

800

2.2/25

750

Surge Ratings

Series

IPP

8x20 µs

Amps

ITSM

60 Hz

Amps

di/dt

Amps/µs

5000

400

500

P3602ACMC 数据表(PDF) 82 Page - Teccor Electronics

P3602ACMC 数据表(HTML) 82 Page - Teccor Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载