CP5.241, CP5.241-C1,

CP5.241-S1, CP5.241-S2

CP-Series

Aug. 2017 / Rev. 0.1 DS-CP5.241-EN

All parameters are typical values specified at 24V, 5A output, 230Vac input, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

P R E L I M I N A R Y

This buffer unit is a supplementary device for DC 24V power supplies. It delivers power to

bridge typical mains failures or extends the hold-up

time after turn-off of the AC power. In times when

the power supply provides sufficient voltages, the

buffer unit stores energy in integrated electrolytic

capacitors. In case of mains voltage fault, this energy

is released again in a regulated process. One buffer

module can deliver 20A additional current.

21/26

The buffer unit does not require any control wiring. It can be added in parallel to the load

circuit at any given point. Buffer units can be added in parallel to increase the output

ampacity or the hold-up time.

DC

Buffer

Unit(s)

Power

Supply

Load

AC

+

-

This bracket is used to mount the devices on a wall/panel without utilizing a DIN-Rail. It is suitable for CP5.241,

CP5.241-C1, CP5.241-S1 and CP5.241-S2.

The bracket can be mounted without detaching the DIN-rail brackets.

Fig. 23-1 Isometric view

(Picture shows the CP5.241)

Fig. 23-2 Isometric view-

(Picture shows the CP5.241)

Fig. 23-3 Isometric view

(Picture shows the CP5.241)

Fig. 23-4 Wall/panel mounting, front

view (Picture shows the CP5.241)

Fig. 23-5 Hole pattern for wall

mounting

Fig. 23-6 Wall/panel mounting,

side view (Picture shows the CP5.241)