MEAS MS8607 DCS FOR ZedBoard

Digital Pressure and Humudity Sensor

07/2016

Page 4

connect the power adapter to the barrel jack on the ZedBoard (3). Finally connect the micro-USB cable to the micro-USB

port of the ZedBoard that is labeled

“UART” (4). The USB cable will facilitate UART transmissions for the console

application.

5. Turn on the power to the board with the switch next to the barrel jack. When the board powers up, the ZedBoard will

illuminate a green power LED. After close to 30 seconds, the FPGA will be successfully programmed by the boot image

on the SD card and a blue “Done” LED will illuminate on the ZedBoard. Your hardware should appear as shown below. If

the board was powered on before this step, turn the power off and repeat this step.

ZedBoard and Digilent Pmod

™ are trademarks.