Connection Diagram

20134902

16-Lead TSSOP, LLP

See NS Package Numbers MTC16 and SDA16A

Ordering Information

Ordering Number

Package Type

NSC Package Drawing

Supplied As

LM5115MM

TSSOP-16

MTC16

1000 shipped as Tape & Reel

LM5115MMX

TSSOP-16

MTC16

3500 shipped as Tape & Reel

LM5115SD

LLP-16

SDA16A

Available Soon

LM5115SDX

LLP-16

SDA16A

Available Soon

Pin Description

PIN

NAME

DESCRIPTION

APPLICATION INFORMATION

1

CS

Current Sense amplifier positive input

A low inductance current sense resistor is connected between

CS and VOUT. Current limiting occurs when the differential

voltage between CS and VOUT exceeds 45mV (typical).

2

VOUT

Current sense amplifier negative input

Connected directly to the output voltage. The current sense

amplifier operates over a voltage range from 0V to 12V at the

VOUT pin.

3

AGND

Analog ground

Connect directly to the power ground pin (PGND).

4

CO

Current limit output

For normal current limit operation, connect the CO pin to the

COMP pin. Leave this pin open to disable the current limit

function.

5

COMP

Compensation. Error amplifier output

COMP pin pull-up is provided by an internal 300uA current

source.

6

FB

Feedback. Error amplifier inverting input

Connected to the regulated output through the feedback resistor

divider and compensation components. The non-inverting input

of the error amplifier is internally connected to the SS pin.

7

SS

Soft-start control

An external capacitor and the equivalent impedance of an

internal resistor divider connected to the bandgap voltage

reference set the soft-start time. The steady state operating

voltage of the SS pin equal to 0.75V (typical).

8

RAMP

PWM Ramp signal

An external capacitor connected to this pin sets the ramp slope

for the voltage mode PWM. The RAMP capacitor is charged

with a current that is proportional to current into the SYNC pin.

The capacitor is discharged at the end of every cycle by an

internal MOSFET.

www.national.com

2