Typical Performance Characteristics

www.vishay.com

Vishay Sprague

Revision: 21-Jun-17

2

Document Number: 40192

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

Note

• At +25 °C, the leakage current shall not exceed the value listed in the Standard Ratings table

At +85 °C, the leakage current shall not exceed 10 times the value listed in the Standard Ratings table

At +125 °C, the leakage current shall not exceed 12 times the value listed in the Standard Ratings table

At +150 °C, the leakage current shall not exceed 15 times the value listed in the Standard Ratings table

At +175 °C, the leakage current shall not exceed 18 times the value listed in the Standard Ratings table

TYPICAL LEAKAGE CURRENT TEMPERATURE FACTOR

ENVIRONMENTAL PERFORMANCE CHARACTERISTICS

ITEM

CONDITION

POST TEST PERFORMANCE

Surge voltage

Post application of surge voltage (as specified in

the table above) in series with a 33

Ω resistor at

the rate of 30 s ON, 30 s OFF, for 1000 successive

test cycles at 85 °C.

Capacitance change

Dissipation factor

Leakage current

Within ± 10 % of initial value

Initial specified limit

Initial specified limit

Life test at +85 °C

1000 h application of rated voltage at 85 °C.

MIL-STD-202, method 108

Capacitance change

Dissipation factor

Leakage current

Within -20 % / +10 % of initial value

Initial specified limit

Shall not exceed 125 % of initial limit

Life test at +125 °C

1000 h application 2/3 of rated voltage at 125 °C.

MIL-STD-202, method 108

Capacitance change

Dissipation factor

Leakage current

Within -20 % / +10 % of initial value

Initial specified limit

Shall not exceed 125 % of initial limit

Humidity tests

At 60 °C / 90 % RH 1000 h, biased

Capacitance change

Dissipation factor

Leakage current

Within -10 % / +20 % of initial value

Not to exceed 150 % of initial limit

Shall not exceed 200 % of initial limit

Thermal shock

MIL-STD-202, method 107, test condition A

(-55 °C / +85 °C, for 1000 cycles)

Capacitance change

Dissipation factor

Leakage current

Within ± 10 % of initial value

Initial specified limit

Initial specified limit

Percent of Rated Voltage

100

10

1

0.1

0.01

0.001

0

102030405060708090 100

+125 °C

+85 °C

+55 °C

+25 °C

-55 °C

+150 °C

+175 °C

0 °C