TMCS

www.vishay.com

Vishay Polytech

Revision: 26-Oct-17

4

Document Number: 40177

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

Note

• Test conditions per JIS C5101-1

POWER DISSIPATION

CASE CODE

MAXIMUM PERMISSIBLE POWER DISSIPATION AT +25 °C (W) IN FREE AIR

A

0.078

B

0.096

C

0.100

E

0.120

STANDARD PACKAGING QUANTITY

CASE CODE

UNITS PER 7" REEL

A

2000

B

2000

C

500

E

500

PERFORMANCE CHARACTERISTICS

ITEM

CONDITION

POST TEST PERFORMANCE

Temperature



characteristics

Measure the specified

characteristics in each stage

Specified

initial value

-55 °C

+85 °C

+125 °C

Capacitance change

-

-10 % to 0 %

0 % to +10 %

0 % to +12 %

Dissipation factor (%)

44

5

5

66

7

7

Leakage current

Not more

than 0.01 CV

or 0.5 μA

whichever is

greater

-

Not more

than 0.1 CV

or 5 μA

whichever is

greater

Not more

than 0.125 CV

or 6.25 μA

whichever is

greater

Solder heat

resistance

Solder dip: 260 °C ± 5 °C



A, B case: 10 s ± 1 s



C, E case: 5 s ± 0.5 s



Reflow 260 °C, 10 s ± 1 s

Capacitance change

Within ± 5 % of initial value

Dissipation factor

Shall not exceed initial specified value

Leakage current

Shall not exceed initial specified value

Moisture



resistance



no load

Leave at 40 °C and 90 % to



95 % RH for 500 h

Capacitance change

Within ± 5 % of initial value

Dissipation factor

Shall not exceed initial specified value

Leakage current

Shall not exceed initial specified value

High



temperature



load

85 °C. The rated voltage is

applied for 2000 h

Capacitance change

Within ± 10 % of initial value

Dissipation factor

Shall not exceed initial specified value

Leakage current

Shall not exceed 125 % of initial specified value

Thermal shock

Leave at -55 °C, normal

temperature, 125 °C, and

normal temperature for 30 min,

3 min, 30 min, and 3 min.



Repeat this operation 20 times

running

Capacitance change

Within ± 5 % of initial value

Dissipation factor

Shall not exceed initial specified value

Leakage current

Shall not exceed initial specified value

Moisture



resistance



load

Leave at 40 °C and 90 % to

95 % RH. The rated voltage

applied for 500 h

Capacitance change

Within ± 10 % of initial value

Dissipation factor

Shall not exceed 150 % of initial specified value

Leakage current

Shall not exceed 125 % of initial specified value

Failure rate

85 °C. The rated voltage is

applied through a protective

resistor of 1

/V

1 % / 1000 h