M24C08-RMB6TG datasheet(12/29 Pages) STMICROELECTRONICS

12 / 29 page

M24C16, M24C08, M24C04, M24C02, M24C01

12/29

Sequential Read

This operation can be used after a Current Ad-

dress Read or a Random Address Read. The bus

master does acknowledge the data byte output,

and sends additional clock pulses so that the de-

vice continues to output the next byte in sequence.

To terminate the stream of bytes, the bus master

must not acknowledge the last byte, and must

generate a Stop condition, as shown in Figure 9..

The output data comes from consecutive address-

es, with the internal address counter automatically

incremented after each byte output. After the last

memory address, the address counter ‘rolls-over’,

and the device continues to output data from

memory address 00h.

Acknowledge in Read Mode

For all Read commands, the device waits, after

each byte read, for an acknowledgment during the

9th bit time. If the bus master does not drive Serial

Data (SDA) Low during this time, the device termi-

nates the data transfer and switches to its Stand-

by mode.

INITIAL DELIVERY STATE

The device is delivered with the memory array

erased: all bits are set to 1 (each byte contains

FFh).

M24C08-RMB6TG 数据表(PDF) 12 Page - STMicroelectronics