2017-11-14

28

LRTB GFUG

Remarks:

1)

Brightness values are measured during a current pulse of typical 25 ms, with an internal reproducibility of +/- 8 % and

an expanded uncertainty of +/- 11 % (acc. to GUM with a coverage factor of k = 3).



2)

Driving the LED in reverse direction is suitable for short term application.

3)

R

4)

The dominant wavelength is measured at a current pulse of typical 25 ms, with an internal reproducibility of +/- 0,5 nm

and an expanded uncertainty of +/- 1 nm (acc. to GUM with a coverage factor of k=3).

5)

The forward voltage is measured during a current pulse of typical 8 ms, with an internal reproducibility of +/- 0,05 V and

an expanded uncertainty of +/- 0,1 V (acc. to GUM with a coverage factor of k=3).



6)

Due to the special conditions of the manufacturing processes of LED, the typical data or calculated correlations of

technical parameters can only reflect statistical figures. These do not necessarily correspond to the actual parameters

of each single product, which could differ from the typical data and calculated correlations or the typical characteristic

line. If requested, e.g. because of technical improvements, these typ. data will be changed without any further notice.

7)

In the range where the line of the graph is broken, you must expect higher brightness differences between single LEDs

within one packing unit.



Dimming range for direct current mode max. 5:1 for red



8)

Dimensions are specified as follows: mm (inch)

9)

Package able to withstand TTW-soldering heat acc. to CECC 00802

to cause the failure of that life-support device or system, or to affect its safety or the effectiveness of that device or

system.







(a) to be implanted in the human body,



or



(b) to support and/or maintain and sustain human life. If they fail, it is reasonable to assume that the health and the life

of the user may be endangered.



