LPC2131 datasheet(23/41 Pages) PHILIPS

23 / 41 page

9397 750 14868

Preliminary data sheet

Rev. 02 — 15 April 2005

23 of 41

Philips Semiconductors

LPC2131/2132/2134/2136/2138

Single-chip 16/32-bit microcontrollers

• External Event Counter or timer operation.

• Four 32-bit capture channels per timer/counter that can take a snapshot of the timer

value when an input signal transitions. A capture event may also optionally generate

an interrupt.

• Four 32-bit match registers that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Four external outputs per timer/counter corresponding to match registers, with the

following capabilities:

– Set LOW on match.

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

6.18 Watchdog timer

The purpose of the watchdog is to reset the microcontroller within a reasonable amount of

time if it enters an erroneous state. When enabled, the watchdog will generate a system

reset if the user program fails to ‘feed’ (or reload) the watchdog within a predetermined

amount of time.

6.18.1 Features

• Internally resets chip if not periodically reloaded.

• Debug mode.

• Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be

disabled.

• Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.

• Flag to indicate watchdog reset.

• Programmable 32-bit timer with internal pre-scaler.

• Selectable time period from (TPCLK × 256 × 4) to (TPCLK × 232 × 4) in multiples of

TPCLK × 4.

6.19 Real-time clock

The Real-Time Clock (RTC) is designed to provide a set of counters to measure time

when normal or idle operating mode is selected. The RTC has been designed to use little

power, making it suitable for battery powered systems where the CPU is not running

continuously (Idle mode).

6.19.1 Features

• Measures the passage of time to maintain a calendar and clock.

• Ultra-low power design to support battery powered systems.

LPC2131 数据表(PDF) 23 Page - NXP Semiconductors

LPC2131 数据表(HTML) 23 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

数据表下载