AD7652AST datasheet(21/29 Pages) AD

21 / 29 page

AD7652

CURRENT

CONVERSION

BUSY

DATA

BUS

t12

t13

02964-0-013

DIGITAL INTERFACE

The AD7652 has a versatile digital interface; it can be interfaced

with the host system by using either a serial or a parallel

interface. The serial interface is multiplexed on the parallel data

bus. The AD7652 digital interface also accommodates both 3 V

and 5 V logic by simply connecting the OVDD supply pin of the

AD7652 to the host system interface digital supply. Finally, by

using the OB/2C input pin, both twos complement or straight

binary coding can be used.

The two signals, CS and RD, control the interface. CS and RD

have a similar effect because they are OR’d together internally.

When at least one of these signals is HIGH, the interface

outputs are in high impedance. Usually CS allows the selection

of each AD7652 in multicircuit applications and is held LOW in

a single AD7652 design. RD is generally used to enable the

conversion result on the data bus.

PARALLEL INTERFACE

The AD7652 is configured to use the parallel interface when

SER/PAR is held LOW. The data can be read either after each

conversion, which is during the next acquisition phase, or

during the following conversion, as shown in F

and

, respectively. When the data is read during the

conversion, however, it is recommended that it is read only

during the first half of the conversion phase. This avoids any

potential feedthrough between voltage transients on the digital

interface and the most critical analog conversion circuitry.

igure 29

Figure 29. Slave Parallel Data Timing for Reading (Read after Convert)

Figure 30

Figure 30. Slave Parallel Data Timing for Reading (Read during Convert)

CONVERSION

t12

t13

BUSY

DATA

BUS

02964-0-014

CNVST,

CS = 0

The BYTESWAP pin allows a glueless interface to an 8-bit bus.

As shown in

, the LSB byte is output on D[7:0] and the

MSB is output on D[15:8] when BYTESWAP is LOW. When

BYTESWAP is HIGH, the LSB and MSB bytes are swapped and

the LSB is output on D[15:8] and the MSB is output on D[7:0].

By connecting BYTESWAP to an address line, the 16-bit data

can be read in two bytes on either D[15:8] or D[7:0].

Figure 31

Figure 31. 8-Bit Parallel Interface

BYTESWAP

PINS D[15:8]

PINS D[7:0]

HI-Z

HIGH BYTE

LOW BYTE

HIGH BYTE

HI-Z

t12

t13

02965-0-025

SERIAL INTERFACE

The AD7652 is configured to use the serial interface when

SER/PAR is held HIGH. The AD7652 outputs 16 bits of data,

MSB first, on the SDOUT pin. This data is synchronized with

the 16 clock pulses provided on the SCLK pin. The output data

is valid on both the rising and falling edges of the data clock.

Rev. 0 | Page 20 of 28

AD7652AST 数据表(PDF) 21 Page - Analog Devices

AD7652AST 数据表(HTML) 21 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

数据表下载