www.roithner-laser.com

4

Precautions

Soldering:

 Do avoid overheating of the LED

 Do avoid electrostatic discharge (ESD)

 Do avoid mechanical stress, shock, and vibration

 Do only use non-corrosive flux

 Do not apply current to the LED until it has cooled down to room temperature after soldering

 Do not solder the LED closer than 3 mm from the base of the lead.

Recommended soldering conditions:

Soldering Conditions

Recommended Soldering Patterns

Unit: mm

Above table specifies the maximum allowed duration and temperature during soldering. It is strongly

advised to perform soldering at the shortest time and lowest temperature possible.

Cleaning:

Cleaning with isopropyl alcohol, propanol, or ethyl alcohol is recommended

DO NOT USE acetone, chloroseen, trichloroethylene, or MKS

DO NOT USE ultrasonic cleaners

Static Electricity:

LEDs are sensitive to electrostatic discharge (ESD). Precautions against ESD must be taken

when handling or operating these LEDs. Surge voltage or electrostatic discharge can result in

complete failure of the device.

Radiation:

During operation these LEDs do emit light, which could be hazardous to skin and eyes, and may

cause cancer. Do avoid exposure to the emitted light. Protective glasses if needed. It is further

advised to attach a warning label on products/systems.

Operation:

Do only operate LEDs with a current source.

Running these LEDs from a voltage source will result in complete failure of the device.

Current of a LED is an exponential function of the voltage across it. Usage of current regulated drive

circuits is mandatory.

© All Rights Reserved

The above specifications are for reference purpose only and subjected to change without prior notice