CEC1702 EFUSE GENERATOR TOOL

USER’S GUIDE

 2017 Microchip Technology Inc.

DS50002598A-page 24

Appendix B. Programming Steps For MikroE Tool

B.1

STEPS TO PROGRAM THE EFUSE USING MIKROPROG SUITE FOR ARM

If the user plans to use the mikroProg Suite for ARM for programming, the following are

the steps for programming the Efuse

1. Power up the Clicker board.

2. Connect the microProg to the Clicker board and the computer as shown in Fig-

ure B-1: “CEC1702 Clicker board Setup”.

3. Double click on the mikroProg suite for ARM tool program shortcut and open the

mikroProg tool. Figure B-2: “mikroProg Suite for ARM Screen” would open

up.

FIGURE B-1:

CEC1702 CLICKER BOARD SETUP