SC14WAMDECT-SF datasheet(30/36 Pages) DIALOG

30 / 36 page

Datasheet

Revision 3.0

23-Jul-2015

CFR0011-120-00-FM Rev 5

30 of 36

SC14WAMDECT SF

Wireless Audio Module

FINAL

9.3 END APPLICATION APPROVAL

The module is intended to be used in an end applica-

tion. Type approval concerning the end product, except

for the module, should of course be done. Please con-

tact a test house in order to clarify what is needed.

9.4 SAFETY REQUIREMENTS

This section provides of an overview of the safety

requirements that must be adhered to when working

with the SC14WAMDECT SF.

• The specific external power supply for the

SC14WAMDECT SF has to fulfil the requirements

according to clause 2.5 (Limited power source) of

this standard EN 60950-1:2006.

• Interconnection circuits shall be selected to provide

continued conformance to the requirements of

clause 2.2 for SELV (Safety Extra Low Voltage) cir-

cuits according to EN 60950-1:2006 after making

connections.

• Interface type: not subjected to overvoltages (i.e.

does not leave the building).

• Requirements additional to those specified in this

standard may be necessary for:

• Equipment intended for operation in special envi-

ronments (for example, extremes of temperature,

excessive dust, moisture or vibration, flammable

gases and corrosive or explosive atmospheres).

• Equipment intended to be used in vehicles, on

board ships or aircraft, in tropical countries or at

altitudes greater than 2000 m.

• Equipment intended for use where ingress of

water is possible.

• Installation by qualified personnel only!

• The product is a component intended for installation

and use in complete equipment. The final accept-

ance of the component is dependent upon its instal-

lation and use in complete equipment.

SC14WAMDECT-SF 数据表(PDF) 30 Page - Dialog Semiconductor

SC14WAMDECT-SF 数据表(HTML) 30 Page - Dialog Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载