FIRETRAP

PLEASE READ BEFORE ATTEMPTING INSTALLATION:

This system is supplied complete with cable in order to connect to the Clay Trap Release.

Warning : Not all Clay Traps have the same wiring convention!

The system is pre-wired (as diagram below) to operate with most trap releases, before connecting, CHECK

YOUR CONNECTIONS. (using a voltmeter) if you are in any doubt, DO NOT CONNECT THE SYSTEM, consult a

qualified Electrician. Although the system operates on 12-30V DC damage may occur to the receiver unit if

wrong connections are made.

Installation Notes

An ideal installation would be to firmly fix the FIRETRAP-RX approx. 2 metres from the ground, in direct sight

of the transmitter. Lowering the height or having obstacles between transmitter and receiver will reduce

range!

Connecting Power to the Receiver unit

The receiver unit requires the following connections to operate:

- 12V supply (Brown wire as supplied)

- OV Supply (Yell/GRN wire as supplied)

When the Receiver unit has power connected the Power LED will illuminate. This must be ‘on’ for the system

to operate.

Note:

If you are pairing multiple transmitter i.e. If you have purchased receivers and transmitters separately. Follow

the procedure detailed on page 4 to configure your chosen system. FIRETRAP-S1 systems are sold pre-paired.

Relay 1

Relay 2

Relay 3

0V

12V

NO

NC

COM

LRN LED

BUZZER

REED SWITCH

LRN SWITCH

PWR LED

ACK LED

JUMPER LINKS

ANTENNA

FIRETRAP Receiver Wiring

This diagram shows the standard

wiring configuration and may be

adapted to fit Traps requiring other

switching types.