4800 Great America Parkway, Suite 202

Tel: 408-235-8680

Santa Clara, CA 95054

Fax: 408-235-8685

6

EN29F080

Rev. C, Issue Date: 2001/07/05

USER MODE DEFINITIONS

Standby Mode

The EN29F080 has a CMOS-compatible standby mode, which reduces the current to

< 1µA (typical).

Read Mode

The device is automatically set to reading array data after device power-up. No commands are required to

retrieve data. The device is also ready to read array data after completing an Embedded Program or

Embedded Erase algorithm.

After the device accepts an Erase Suspend command, the device enters the Erase Suspend mode. The

system can read array data using the standard read timings, except that if it reads at an address within

erase-suspended sectors, the device outputs status data. After completing a programming operation in

the Erase Suspend mode, the system may once again read array data with the same exception. See

“Erase Suspend/Erase Resume Commands” for more additional information.

The system

must issue the reset command to re-enable the device for reading array data if DQ5 goes

high, or while in the autoselect mode. See the “Reset Command” additional details.

Output Disable Mode

The output pins are placed in a high impedance state.

Auto Select Identification Mode

The autoselect mode provides manufacturer and device identification, and sector protection

verification, through identifier codes output on DQ7–DQ0. This mode is primarily intended for

programming equipment to automatically match a device to be programmed with its corresponding

programming algorithm. However, the autoselect codes can also be accessed in-system through the

command register.

address pin A9. Address pins A6, A1, and A0 must be as shown in Autoselect Codes (High Voltage

Method) table. In addition, when verifying sector protection, the sector address must appear on the

appropriate highest order address bits. Refer to the corresponding Sector Address Tables. The

Command Definitions table shows the remaining address bits that are don’t-care. When all

necessary bits have been set as required, the programming equipment may then read the

corresponding identifier code on DQ7–DQ0.

To access the autoselect codes in-system; the host system can issue the autoselect command via

the command register, as shown in the Command Definitions table. This method does not require