In addition to the minimal parts required for the application

circuit, a measurement filter is provided on the evaluation

circuit board so that conventional audio measurements can

be conveniently made without additional equipment. This is a

balanced input / grounded differential output low pass filter

with a 3dB frequency of approximately 35kHz and an on

board termination resistor of 300

Ω (see schematic). Note

that the capacitive load elements are returned to ground.

This is not optimal for common mode rejection purposes, but

due to the independent pulse format at each output there is

a significant amount of high frequency common mode com-

ponent on the outputs. The grounded capacitive filter ele-

ments attenuate this component at the board to reduce the

high frequency CMRR requirement placed on the analysis

instruments.

Even with the grounded filter the audio signal is still differ-

ential, necessitating a differential input on any analysis in-

strument connected to it. Most lab instruments that feature

BNC connectors on their inputs are NOT differential re-

sponding because the ring of the BNC is usually grounded.

The commonly used Audio Precision analyzer is differential,

but its ability to accurately reject fast pulses of 160nS width

is questionable necessitating the on board measurement

filter. When in doubt or when the signal needs to be single-

ended, use an audio signal transformer to convert the differ-

ential output to a single ended output. Depending on the

audio transformer’s characteristics, there may be some at-

tenuation of the audio signal which needs to be taken into

account for correct measurement of performance.

Measurements made at the output of the measurement filter

suffer attenuation relative to the primary, unfiltered outputs

even at audio frequencies. This is due to the resistance of

the inductors interacting with the termination resistor (300

Ω)

and is typically about -0.35dB (4%). In other words, the

voltage levels (and corresponding power levels) indicated

through the measurement filter are slightly lower than those

that actually occur at the load placed on the unfiltered out-

puts. This small loss in the filter for measurement gives a

lower output power reading than what is really occurring on

the unfiltered outputs and its load.

LM4665 MSOP BOARD ARTWORK

Composite View

Silk Screen

200270B2

200270B3

Top Layer

Bottom Layer

200270B4

200270B5

www.national.com

14