LPV511 datasheet(5/14 Pages) NSC

5 / 14 page

12V Electrical Characteristics (Note 5) (Continued)

Unless otherwise specified, all limits are guaranteed for T

J = 25˚C, V

+ = 12V, V− = 0V, V

CM =VO =V

+/2, and R

L = 100 k

Ω to

+/2. Boldface limits apply to the temperature range of −40˚C to 85˚C.

Symbol

Parameter

Conditions

Min

(Note 6)

Typ

(Note 7)

Max

(Note 6)

Units

Slew Rate (Note 11)

V = +1, VO ramped from 1V to 11V

5.25

3.10

7.0

V/ms

GBW

Gain Bandwidth Product

L =1M

Ω,C

L=50pF

kHz

Phase Margin

L =1M

Ω,C

L=50pF

deg

Input-Referred Voltage Noise

f = 100 Hz

320

nV/

Input-Referred Current Noise

f = 10 Hz

.02

pA/

f = 1 kHz

.01

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is

intended to be functional, but specific performance is not guaranteed. For guaranteed specifications and the test conditions, see the Electrical Characteristics Tables.

Note 2: Human Body Model: 1.5 k

Ω in series with 100 pF. Machine Model: 0Ω in series with 200 pF.

Note 3: The maximum power dissipation is a function of TJ(MAX), θJA, and TA. The maximum allowable power dissipation at any ambient temperature is

PD =(TJ(MAX) -TA)/ θJA . All numbers apply for packages soldered directly onto a PC board.

Note 4: Output short circuit duration is infinite for V+ < 6V at room temperature and below. For V+ > 6V, allowable short circuit duration is 1.5 ms.

Note 5: Electrical table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of

the device.

Note 6: Limits are 100% production tested at 25˚C. Limits over the operating temperature range are guaranteed through correlations using the Statistical Quality

Control (SQC) method.

Note 7: Typical values represent the most likely parametric norm at the time of characterization.

Note 8: Offset voltage average drift is determined by dividing the change in VOS at temperature extremes into the total temperature change.

Note 9: Positive current corresponds to current flowing into the device.

Note 10: The Short Circuit Test is a momentary test. See (Note 4).

Note 11: Slew rate is the average of the rising and falling slew rates.

LPV511 数据表(PDF) 5 Page - National Semiconductor (TI)

LPV511 数据表(HTML) 5 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

数据表下载