SFECV10M7GA00-R0 datasheet(50/57 Pages) MURATA

50 / 57 page

Please read CAUTION and Notice in this catalog for safety. This catalog has only typical specifications. Therefore you are requested

to approve our product specification or to transact the approval sheet for product specification, before your ordering.

P61E7.pdf 01.10.17

Lead Type Discriminators Notice

s Notice (Soldering and Mounting)

The component cannot be withstand washing.

s Notice (Handling)

1. Do not use this product with bend. The component

may be damaged if excess mechanical stress is

applied to it mounted on the printed circuit board.

2. The component may be damaged when an excess stress

will be applied.

3. All kinds of re-flow soldering must not be applied

on the component.

4. Do not clean or wash the component as it is not

hermetically sealed.

5. Do not use strong acidity flux, more than 0.2wt%

chlorine content, in flow soldering.

6. In case of covering discriminator with over coat,

conditions such as material of resin, cure

temperature, and so on should be evaluated well.

7. Accurate test circuit values are required to

measure electrical characteristics. It may be a

cause of mis-correlation if there is any deviation,

especially stray capacitance, from the test

circuit in the specification.

SFECV10M7GA00-R0 数据表(PDF) 50 Page - Murata Manufacturing Co., Ltd.