INMP441ACEZ-R7 datasheet(10/21 Pages) ETC1

10 / 21 page

INMP441

THEORY OF OPERATION

The INMP441 is a high-performance, low-power, digital-output, omni-directional MEMS microphone with a bottom port. The

complete INMP441 solution consists of a MEMS sensor, signal conditioning, an analog-to-digital converter, anti-aliasing filters,

power management, and an industry-standard 24-bit I²S interface.

The INMP441 complies with the TIA-920 Telecommunications Telephone Terminal Equipment Transmission Requirements for

Wideband Digital Wireline Telephones standard.

UNDERSTANDING SENSITIVITY

The casual user of digital microphones may have difficulty understanding the sensitivity specification. Unlike an analog microphone

(whose specification is easily confirmed with an oscilloscope), the digital microphone output has no obvious unit of measure.

The INMP441 has a nominal sensitivity of −26 dBFS at 1 kHz with an applied sound pressure level of 94 dB. The units are in decibels

referred to full scale. The INMP441 default full-scale peak output word is 223 − 1 (integer representation), and −26 dBFS of that scale

is (223 − 1) × 10(−26/20) = 420,426. A pure acoustic tone at 1 kHz having a 1Pa RMS amplitude results in an output digital signal whose

peak amplitude is 420,426.

Although the industry uses a standard specification of 94 dB SPL, the INMP441 test method applies a 104 dB SPL signal. The higher

sound pressure level reduces noise and improves repeatability. The INMP441 has excellent gain linearity, and the sensitivity test

result at 94 dB is derived with very high confidence from the test data.

POWER MANAGEMENT

The INMP441 has three different power states: normal operation, standby mode, and power-down mode.

Normal Operation

The microphone becomes operational 218 clock cycles (85 ms with SCK at 3.072 MHz) after initial power-up. The CHIPEN pin then

controls the power modes. The part is in normal operation mode when SCK is active and the CHIPEN pin is high.

Standby Mode

The microphone enters standby mode when the serial-data clock SCK stops and CHIPEN is high. Normal operation resumes 214 clock

cycles (5 ms with SCK at 3.072 MHz) after SCK restarts.

The INMP441 should not be transitioned from standby to power-down mode, or vice versa. Standby mode is only intended to be

entered from the normal operation state.

Power-Down Mode

The microphone enters power-down mode when CHIPEN is low, regardless of the SCK operation. Normal mode operation resumes

217 SCK clock cycles (43 ms with SCK at 3.072 MHz) after CHIPEN returns high while SCK is active.

It always takes 217 clock cycles to restart the INMP441 after VDD is applied.

It is not recommended to supply active clocks (WS and SCK) to the INMP441 while there is no power supplied to VDD. Doing this

continuously turns on ESD protection diodes, which may affect long-term reliability of the microphone.

Startup

The microphones have zero output for the first 218 SCK clock cycles (85ms with SCK at 3.072 MHz) following power-up.

Page 10 of 21

Document Number: DS-INMP441-00

Revision: 1.1

INMP441ACEZ-R7 数据表(PDF) 10 Page - List of Unclassifed Manufacturers

INMP441ACEZ-R7 数据表(HTML) 10 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

数据表下载