IS25LP032D-RKLE:P datasheet(89/118 Pages) ISSI

89 / 118 page

IS25LP032D

IS25WP032D

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A12

08/04/2020

8.41 FAST READ QUAD I/O DTR MODE OPERATION IN SPI MODE (FRQDTR, EDh)

The FRQDTR instruction enables Double Transfer Rate throughput on quad I/O of the device in read mode.

A Quad Enable (QE) bit of Status Register must be set to "1" before sending the Fast Read Quad I/O instruction.

The address (interleave on 4 I/O pins) is latched on both rising and falling edge of SCK, and data (interleave on 4

I/O pins) shift out on both rising and falling edge of SCK at a maximum frequency. The 8-bit address can be latched-

in at one clock, and 8-bit data can be read out at one clock, which means four bits at the rising edge of clock, the

other four bits at the falling edge of clock.

The first address byte can be at any location. The address is automatically increased to the next higher address

after each byte data is shifted out, so the whole memory can be read out with a single FRQDTR instruction. The

address counter rolls over to 0 when the highest address is reached. Once writing FRQDTR instruction, the

following address/dummy/data out will perform as 8-bit instead of previous 1-bit.

The sequence of issuing FRQDTR instruction is: CE# goes low  Sending FRQDTR instruction (1-bit per clock)

 24-bit address interleave on IO3, IO2, IO1 & IO0 (8-bit per clock)  6 dummy clocks (configurable, default is 6

clocks)  Data out interleave on IO3, IO2, IO1 & IO0 (8-bit per clock)  End FRQDTR operation by driving CE#

high at any time during data out.

If AXh (

where X is don’t care) is input for the mode bits during dummy cycles, the device will enter AX read operation

mode which enables subsequent FRQDTR execution skips command code. It saves cycles as described in Figure

8.68. When the code is different from AXh, the device exits the AX read operation. After finishing the read operation,

device becomes ready to receive a new command.

If the FRQDTR instruction is issued while a Program/Erase/Write Status Register cycle is in progress (WIP=1), the

instruction will be rejected without any effect on the current cycle.

IS25LP032D-RKLE:P 数据表(PDF) 89 Page - Integrated Silicon Solution, Inc