IS25LP064A-RHLA1 datasheet(31/99 Pages) ISSI

31 / 99 page

IS25LP064A/032A

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A

11/06/2015

8.5 FAST READ DUAL OUTPUT OPERATION (FRDO, 3Bh)

The FRDO instruction is used to read memory data on two output pins each at up to a 133MHz clock.

The FRDO instruction code is followed by three address bytes (A23

– A0) and a dummy byte (8 clocks),

transmitted via the IO0 line, with each bit latched-in during the rising edge of SCK. Then the first data byte

addressed is shifted out on the IO1 and IO0 lines, with each pair of bits shifted out at a maximum frequency fCT,

during the falling edge of SCK. The first bit (MSB) is output on IO1. Simultaneously the second bit is output on

IO0.

The first byte addressed can be at any memory location. The address is automatically incremented by one after

each byte of data is shifted out. W hen the highest address is reached, the address counter will roll over to the

000000h address, allowing the entire memory to be read with a single FRDO instruction. The FRDO instruction

is terminated by driving CE# high (VIH).

If the FRDO instruction is issued while an Erase, Program or Write cycle is in process (BUSY=1) the instruction

is ignored and will not have any effects on the current cycle.

Figure 8.6 Fast Read Dual Output Sequence

CE #

SCK

Data Out 1

Instruction = 3Bh

CE #

SCK

3-byte Address

High Impedance

...

Mode 3

Mode 0

...

IO0

IO1

...

Data Out 2

IO0

IO1

8 Dummy Cycles

IS25LP064A-RHLA1 数据表(PDF) 31 Page - Integrated Silicon Solution, Inc

IS25LP064A-RHLA1 数据表(HTML) 31 Page - Integrated Silicon Solution, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99

数据表下载