STM32F722IC datasheet(34/229 Pages) STMICROELECTRONICS

34 / 229 page

Functional overview

STM32F722xx STM32F723xx

34/229

DS11853 Rev 6

Figure 12. Regulator OFF

The following conditions must be respected:

•

VDD should always be higher than VCAP_1 and VCAP_2 to avoid current injection

between power domains.

•

If the time for VCAP_1 and VCAP_2 to reach V12 minimum value is faster than the time for

VDD to reach 1.7 V, then PA0 should be kept low to cover both conditions: until VCAP_1

and VCAP_2 reach V12 minimum value and until VDD reaches 1.7 V (see Figure 13).

•

Otherwise, if the time for VCAP_1 and VCAP_2 to reach V12 minimum value is slower

than the time for VDD to reach 1.7 V, then PA0 could be asserted low externally (see

Figure 14).

•

If VCAP_1 and VCAP_2 go below V12 minimum value and VDD is higher than 1.7 V, then a

reset must be asserted on PA0 pin.

Note:

The minimum value of V12 depends on the maximum frequency targeted in the application.

Note:

On the LQFP64 pin package, the VCAP_2 is not available.

ai18498V3

BYPASS_REG

VCAP_1

VCAP_2

PA0

V12

VDD

NRST

VDD

Application reset

signal (optional)

External VCAP_1/2 power

supply supervisor

Ext. reset controller active

when VCAP_1/2 < Min V12

V12

STM32F722IC 数据表(PDF) 34 Page - STMicroelectronics

STM32F722IC 数据表(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载