厦门市硅兆光电科技有限公司

Xiamen

Silicon-top opto electronics Co.,Ltd.

版权归厦门市硅兆光电科技有限公司所有

www.siliconbillion.com

REV5.0

Mar 2020

7

c)由于 SSR 动作时间很短，输入端的噪声可能会引起 SSR 误动作，所以在输入端环境噪声较大时，应在

输入端接 R/C 回路吸收噪声。

Since the operate time of the relay is extremely short, any noise to input terminal will cause

malfunction of the SSR, So a RC circuit should be connected to input terminal to absorb the

noise in the noisy condition.

d)推荐的使用电路，输出端的尖峰电压可能会引起 SSR 误动作，所以请在输出端应加 R/C 回路或压敏电

子吸收尖峰电压，具体见下图：

Below shows a recommend circuit: Please add a RC circuit or varistor on the load side， as

noise/surge could damage the unit or cause malfunctions.

关于防静电对策/Cautions for Static Electricity

a.使用电烙铁时，对电烙铁前端进行接地。(建议使用低电压用的电烙铁。) When using soldering irons,

either use irons with low leakage current, or ground the tip of the soldering iron. (Use of

low-voltage soldering irons is also recommended.)

b.组装时使用的设备等也应正确地接地。Devices and equipment used in assembly should also be

grounded.

关于焊接/soldering

继电器焊接,260 度情况下焊接时间不能超过 10 秒钟,350 度情况下焊接时间不能超过 5 秒钟。

Soldering must be completed within 10 seconds at 260℃ or within 5 seconds at 350℃.