ISM303DAC datasheet(45/80 Pages) STMICROELECTRONICS

45 / 80 page

DocID030988 Rev 2

45/80

ISM303DAC

Digital interfaces

Data are transmitted in byte format (DATA). Each data transfer contains 8 bits. The number

of bytes transferred per transfer is unlimited. Data is transferred with the Most Significant bit

(MSb) first. If a receiver can’t receive another complete byte of data until it has performed

some other function, it can hold the clock line SCL low to force the transmitter into a wait

state. Data transfer only continues when the receiver is ready for another byte and releases

the data line. If a slave receiver doesn’t acknowledge the slave address (i.e. it is not able to

receive because it is performing some real-time function) the data line must be left high by

the slave. The master can then abort the transfer. A low-to-high transition on the SDA line

while the SCL line is high is defined as a STOP condition. Each data transfer must be

terminated by the generation of a STOP (SP) condition.

In the presented communication format MAK is Master acknowledge and NMAK is No

Master Acknowledge.

Default address:

The accelerometer sensor slave address is 0011101b while magnetic sensor slave address

is 0011110b.

The slave addresses are completed with a Read/Write bit. If the bit was ‘1’ (Read), a

repeated START (SR) condition must be issued after the two sub-address bytes. If the bit is

‘0’ (Write) the master will transmit to the slave with direction unchanged. Table 26 and

Table 27 explain how the SAD+Read/Write bit patterns are composed, listing all the

possible configurations.

Linear acceleration sensor: the default (factory setting) 7-bit slave address is

0011101b.

Table 26. SAD+Read/Write patterns

Magnetic field sensor: the default (factory setting) 7-bit slave address is 0011110b.

Table 27. SAD + Read/Write patterns

Table 25. Transfer when master is receiving (reading) multiple bytes of data from slave

Master ST SAD+W

SUB

SR SAD+R

MAK

NMAK SP

Slave

SAK

DATA

DAT

DATA

Command

SAD[6:0]

R/W

SAD+R/W

Read

0011101

00111011

Write

0011101

00111010

Command

SAD[6:0]

R/W

SAD + R/W

Read

0011110

00111101 (3Dh)

Write

0011110

00111100 (3Ch)

ISM303DAC 数据表(PDF) 45 Page - STMicroelectronics

ISM303DAC 数据表(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

数据表下载