| 数据搜索系统,热门电子元器件搜索 |
|
STM32WL55JC 数据表(PDF) 21 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32WL55JC 数据表(HTML) 21 Page - STMicroelectronics |
|
21 / 145 page ![]() DS13293 Rev 1 21/145 STM32WL55/54xx Functional overview 48 Transmitter low output power The transmit low output power up to + 15 dBm on full VDD range (1.8 to 3.6 V), is supported through the RFO_LP RF pin. For this, the REG PA must be supplied from the regulated VFBSMPS supply at 1.55 V, as shown in the figure below. The output power range is programmable in 32 steps of ~1 dB. The power amplifier ramping timing is also programmable.This allows adaptation to meet radio regulation requirements. Figure 4. Low output power PA 3.9.4 Receiver The receive chain comprises a differential low-noise amplifier (LNA), a down-converter to low-IF by mixer operation in quadrature configuration. The I and Q signals are low pass filtered and a Ʃ∆ ADC converts them into the digital domain. In the digital modem, the signals are decimated, further down converted and channel filtered. The demodulation is done according to the selected modulation scheme. The down mixing to low-IF is done by mixing the receive signal with the local RF-PLL located in the negative frequency, where -flo = -frf + -fif. (where flo is the local RF-PLL frequency, frf is the received signal and fif is the intermediate frequency). The wanted signal is located at frf = flo + fif. The receiver features automatic I and Q calibration, that improves image rejection. The calibration is done automatically at startup before using the receiver, and can be requested by command. The receiver supports LoRa, (G)MSK and (G)FSK modulations. 3.9.5 RF-PLL The RF-PLL is used as the frequency synthesizer for the generation of the local oscillator frequency (flo) for both transmit and receive chains. The RF-PLL uses auto calibration and MSv62617V2 Note: Use of the SMPS is optional. When SMPS is not used, the BOM can be reduced by removing the coil between VLXSMPS and VFBSMPS pins. VLXSMPS VFBSMPS (1.55V) VDDPA VR_PA (up to 1.35V) RFO_LP LDO/SMPS REG PA LP PA LDO mode SMPS mode VDDSMPS (1.8 to 3.6V) VDD VLXSMPS VFBSMPS (1.55V) VDDPA VR_PA (up to 1.35V) RFO_LP LDO/SMPS REG PA VDD LP PA VDDSMPS (1.8 to 3.6V) |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |