5.11

Decoupling capacitor

In order to ensure op-amp full functionality, it is mandatory to place a decoupling capacitor of at least 22 nF as

close as possible to the op-amp supply pins. A good decoupling helps to reduce electromagnetic interference

impact.

5.12

Macro model

Accurate macro models of the TSV79x device are available on the STMicroelectronics’ website at: www.st.com.

These models are a trade-off between accuracy and complexity (that is, time simulation) of the TSV79x

operational amplifier. They emulate the nominal performance of a typical device at 25 °C within the specified

operating conditions mentioned in the datasheet. They also help to validate a design approach and to select the

right operational amplifier, but they do not replace onboard measurements.

TSV791, TSV792

Decoupling capacitor

DS13480 - Rev 1

page 24/36