MODEL: M2EXDY

M2EXDY SPECIFICATIONS

ES-5170 Rev.1 Page 1/6

http://www.m-system.co.jp/

Super-mini Signal Conditioners with

Display Mini-M M2E Series

CURRENT LOOP SUPPLY

(PC programmable)

Functions & Features

• Adjustments with the front button

• OEL display with good visibility

• Microprocessor based

• Shortcircuit protection

• Segment linearization, square root extraction configurable

• Usable as Isolator for 4 – 20 mA DC signals

Typical Applications

• Various 2-wire transmitters

Mode

Set

Up

Down

83

(3.27)

124

(4.88)

29.5

(1.16)

mm (inch)

MODEL: M2EXDY–[1][2]

ORDERING INFORMATION

• Code number: M2EXDY-[1][2]

Specify a code from below for each [1] and [2].

(e.g. M2EXDY-M2/Q)

• Specify the specification for option code /Q

(e.g. /C01/S01/SET)

INPUT

Current

4 – 20 mA DC (Input resistance 250 Ω)

(Selectable within 0 – 20 mA DC)

OUTPUT – Field-selectable

◆ DC Output

• Current output: 0 - 20 mA DC

• Voltage output: -5 - +5 V DC

• Voltage output: -10 - +10 V DC

[1] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

P: 110 V DC

(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

TERMINAL SCREW MATERIAL

/S01: Stainless steel

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-5170)

Default setting will be used if not otherwise specified.

RELATED PRODUCTS

• M2E configurator software (model: M2ECFG)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual (EM-5147) for the M2E configurator for

applicable cable types.

GENERAL SPECIFICATIONS

Construction: Plug-in

Connection: M3 screw terminals (torque 0.8 N·m)

Screw terminal: Chromated steel (standard) or stainless

steel

Housing material: Flame-resistant resin (gray)

Isolation: Input to output to power

Overrange output: Approx. -7.5 to +107.5 % (Not available

for current output not greater than 0 mA)

Zero adjustment: -5 to +5 % (front)

Span adjustment: 95 to 105 % (front)

Output setting: DIP Switch on side panel (refer to the

instruction manual)

Configuration: Program with front buttons or Via PC.

Programmable features include: Refer to the parameter list.

Configurator connection: 2.5 dia. miniature jack;