MODEL: JPQ2

JPQ2 SPECIFICATIONS

ES-1579 Rev.9 Page 3/5

http://www.m-system.co.jp/

the current signal (0 - 25 mA) into 0 – 2.5 V. A pulse rise

detected when the voltage goes above the detecting level

(input monitor LED ON); a pulse sink detected when it goes

below the level (input monitor LED OFF).

■ Reset Input

Sensing voltage: 4.5 V DC

Detecting level

ON: ≤ 1 V

OFF: ≥ 4 V

50V max.

Amplitude

Vinp-p

t

Volts

DC Offset

■ Voltage pulse waveform

OUTPUT SPECIFICATIONS

■ DC Current: 0 – 20 mA DC

Minimum span: 1 mA

Offset: Max. 1.5 times span

Load resistance: Output drive 15 V max.

■ DC Voltage: -10 – +12 V DC

Minimum span: 5 mV

Offset: Max. 1.5 times span

Load resistance: Output drive 10 mA max.; 5 mA for

negative voltage output; at ≥ 0.5 V

■ Alarm Output: Relay contact

Rated load: 125 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

Maximum switching voltage: 250 V AC or 125 V DC

Maximum switching power: 62.5 VA or 60 W

Minimum load: 10 mV DC @ 1 mA

For maximum relay life with inductive loads, external

protection is recommended.

INSTALLATION

Power input

•AC: Operational voltage range 85 – 132 V,

47 – 66 Hz, approx. 6 VA

•DC: Operational voltage range: Rating ±10 %, or 85 – 150

V for 110 V rating; ripple 10 %p-p max.; Approx. 3.3 W (130

mA at 24 V)

Operating temperature: -5 to +60°C (23 to 140°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 350 g (0.77 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.1 %

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: ≤ 0.5 sec. (0 – 90 %)

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength:

2000 V AC @ 1 minute (input to output to power)

1500 V AC @ 1 minute (input or output or power to alarm

output)

2000 V AC @ 1 minute (circuit to ground)