MODEL: M6SPP

M6SPP SPECIFICATIONS

ES-7989 Rev.6 Page 1/5

http://www.m-system.co.jp/

Tension-Clamp Ultra-Slim Signal Conditioners M6S Series

PULSE ISOLATOR

Functions & Features

• Maintenance-free tension clamp connection

• 5.9-mm wide ultra-slim design

• Low profile allows the M6S module mounted in a 120-mm

deep panel

• Galvanically isolates pulse rate signals

• High-density mounting

• Power indicator and input monitor LED

Typical Applications

• Isolating field pulse signals in order to reduce noises

• Changing e.g. dry contact signal to e.g. 5 V signals

5.9 (.23)

94

(3.70)

102

(4.02)

mm (inch)

MODEL: M6SPP–[1][2][3]–R[4]

ORDERING INFORMATION

• Code number: M6SPP-[1][2][3]-R[4]

Specify a code from below for each [1] through [4].

(e.g. M6SPP-CMN-R/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] INPUT

A1: Open collector

A2: Mechanical contact

C: 5 V pulse (sensitivity 2 V)

D: 12 V/24 V pulse (sensitivity 5 V)

H: Two-wire current pulse

[2] OUTPUT

A1: High frequency open collector (max. 100 kHz)

A2: Low frequency open collector (max. 30 Hz)

M: 5 V pulse

N: 12 V pulse

P: 24 V pulse

[3] OUTPUT LOGIC

N: The same as the input

R: Inverted

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[4] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

GENERAL SPECIFICATIONS

Connection

Input and output: Tension clamp

Power input: Via the Installation Base (model: M6SBS)

or Tension clamp

Housing material: Flame-resistant resin (black)

Isolation: Input to output to power

Chattering protection: Filter provided for mechanical

contact input

Power LED: Green light turns on when the power is supplied.

Input monitor LED

Open collector, Mechanical contact: Orange LED turns

on when the input is ON.

Voltage pulse, 2-wire current pulse: Orange LED turns

on when the input is high.

Input pulse sensing: DC coupled

INPUT SPECIFICATIONS

Excitation: 12 V DC @20 mA, shortcircuit protection

■ Open Collector

Maximum frequency: 100 kHz

Pulse width time requirement: ≥ 5 μsec. for ON and OFF

Sensing: Approx. 11 V DC @2.4 mA

Detecting levels: ≤ 1.8 kΩ/3 V for ON, ≥ 4 kΩ/5 V for OFF

■ Mechanical Contact

Maximum frequency: 30 Hz

Pulse width time requirement: ≥ 10 msec. for ON and OFF

Sensing: Approx. 11 V DC @2.4 mA

Detecting levels: ≤ 1.8 kΩ/3 V for ON, ≥ 4 kΩ/5 V for OFF