MODEL: R3-GC1

R3-GC1 SPECIFICATIONS

ES-8462 Rev.7 Page 1/6

https://www.m-system.co.jp/

Remote I/O R3 Series

CC-Link INTERFACE MODULE

(CC-Link Ver.1.10/Ver.2.00)

Functions & Features

• Enables other protocol interface modules to communicate

with CC-Link data (gateway).

• Recognized as an analog I/O mixed module by other

protocol interface modules.

Typical Applications

• A gateway for CC-Link and Modbus.

109

[4.29]

27.5 [1.08]

130

[5.12]

mm [inch]

MODEL: R3-GC1S[1]

ORDERING INFORMATION

• Code number: R3-GC1S[1]

Specify a code from below for [1].

(e.g. R3-GC1S/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

COMMUNICATION MODE

S: Single

[1] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

CAUTION

• When selecting network modules, note that this unit is not

designed to be used with network modules of certain types

or versions.

• This unit CANNOT be used with R3-NC2, R3-NEIP1, R3-NFx,

and R3-NLx.

• This unit CAN be used with:

R3-NM3 and R3-NML3 of firmware version V1.00 or higher;

R3-NC1, R3-NC3, R3-NDx, R3-NE1, R3-NFL1, R3-NM1,

R3-NM4, and R3-NP1 of firmware version V2.00 or higher;

and

other models of any firmware versions.

PACKAGE INCLUDES...

• Terminating resistor (110 Ω, 0.5 W)

GENERAL SPECIFICATIONS

Connection

Network: Euro type connector terminal

mm)

Internal bus: Via the Installation Base

(model: R3-BSx)

Internal Power: Via the Installation Base

(model: R3-BSx)

RUN contact output: M3 separable screw terminal

(torque 0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: CC-Link to internal bus or internal power to RUN

contact output

RUN indicator: Bi-color (green/red) LED

Green turns ON when CC-Link communication is normal and

fieldbus communication on the R3 Network module side is

also normal; or

Red turns ON when receiving data.

Indication selectable with DIP SW3-4.

ERR indicator: Bi-color (green/red) LED

Green turns ON/blinks in communication errors (OFF with

wire breakdown; Green blinks with setting errors); or

Red turns ON when transmitting data.

Indication selectable with DIP SW3-4.

■ RUN CONTACT OUTPUT

RUN contact: Turns on while the green RUN LED is ON

(only when CC-Link communication and the

field bus built-in the interface module are in normal).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA