MODEL: SC200

SC200 SPECIFICATIONS

ES-6338 Rev.17 Page 9/12

http://www.m-system.co.jp/

MOUNTING REQUIREMENTS unit: mm

68

[68+72×(n - 1)]

+0.7

0

Panel thickness 2.3 – 20

+1

0

■ PANEL CUTOUT unit: mm

• Single mounting

• Clustered mounting

n = number of units

■ Caution

• IP55 is ensured for the front panel of the unit mounted independently according to a panel. Test the sealing at the mounting

surface once the device is installed.

• Set the unit on a vertical surface with its operation buttons at the lower side. Mounting in other directions may cause heat

built up inside the unit and shorten its life span or degrade its performance.

• Ensure that there is sufficient space for ventilation inside a panel. Do not install above the devices that generate high heat

such as heaters, transformers or resistors. Leave at least 30 mm (1.2 inch) space above, below and behind the unit for

maintenance purpose (e.g. wiring, removing or installing).