MODEL: SHSP

SHSP SPECIFICATIONS

ES-9308 Rev.8 Page 2/5

http://www.m-system.co.jp/

• LAN port operating mode (Default setting: Auto

negtiation)

• User password

■ ALARM CONTACT OUTPUT

Turns on when the surge protector life ends,

when the power supply is lost,

or when an internal error is detected.

Rated load:

250 V AC @ 1.5 A (cos ø = 1)(applicable only to AC powered

model.)

30 V DC @ 1.5 A (resistive load)

Minimum load: 5 V DC @ 10 mA

LAN PORT

Standards: IEEE 802.3, IEEE 802.3u, IEEE 802.3x

Number of ports: 8; All ports support AUTO-MDIX

(Automatically sensing cable type, straight-through or cross-

over)

Data transfer rate: 10 Mbps (10BASE-T), 100 Mbps

(100BASE-TX); Supports Auto-Negotiation

Cable: 10BASE-T (STP cable, category 5)

100BASE-TX (STP cable, category 5e)

Maximum segment length: 100 meters

Switching: Store & Forward

Flow control

Full duplex: PAUSE Frames

Half duplex: Back pressure

Buffer: 64 KB

MAC address table: 1024

INSTALLATION

•AC: Approx. 8 VA @ 100 V

Approx. 10 VA @ 200 V

Approx. 11 VA @ 264 V

•DC: Approx. 5.5 W

Operating temperature: -5 to +60°C (23 to 140°F)

Operating humidity: 30 to 95 %RH (non-condensing)

Mounting: DIN rail

Weight

•AC powered: 650 g (1.4 lb)

•DC powered: 600 g (1.3 lb)

PERFORMANCE

Compliant standard: EN 61000-4-5 level X

Between ports: 1kV (combination waveform)

RJ-45 connector contact is out of the scope of this

protection. Using twisted-pair (STP) LAN cable is

effective to reduce risk of fusing contact.

Port to G: 10kV (combination waveform)

FG (shield) to G: 15kV (combination waveform) with the

shortcircuit bar

Voltage protection level

Port to FG or G: 160 V min.

Between each port: 160 V min.

FG to G: 160 V min. (with the shortcircuit bar removed)

Insulation resistance: ≥ 100 MΩ with 100 V DC

(port or FG or G to alarm contact to power)

Dielectric strength: 2000 V AC @ 1 minute

(port or FG or G or power to alarm contact)

1500 V AC @ 1 minute

(port or FG or G to power)

STANDARDS & APPROVALS

The following standards are applied only to DC powered

model.

EU conformity:

EMC Directive

EN 55032 Class A (EMI)

EN 55024 (EMS)

RoHS Directive

EN 50581