AT25QL321-DWF datasheet(30/79 Pages) DIALOG

部件名	AT25QL321-DWF

功能描述	32-Mbit, 1.7V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	79 Pages

Scroll/Zoom	100%

制造商	DIALOG [Dialog Semiconductor]

网页	http://www.dialog-semiconductor.com/

标志

30 / 79 page

AT25QL321

DS-25QL321–131C–5/2017

Figure 7-23. Page Program Instruction (QPI Mode)

7.16 Quad Page Program (33h)

The Quad Page Program instruction is to program the memory as being “0” at previously erased memory areas. The Quad

Page Program takes four pins: IO0, IO1, IO2 and IO3 as address and data input, which can improve programmer performance

and the effectiveness of application of lower clock less than 5MHz. System using faster clock speed will not get more benefit for

the Quad Page Program as the required internal page program time is far more than the time data clock-in.

To use Quad Page Program, the Quad Enable bit must be set, A Write Enable instruction must be executed before the

device will accept the Quad Page Program instruction (Status Register‐1, WEL=1). The instruction is initiated by driving

the CS pin low then sending the instruction code “33h” with following a 24‐bit address (A23‐A0) and at least one data,

into the IO pins. The CS pin must be held low for the entire length of the instruction while data is being sent to the device.

All other functions of Quad Page Program are perfectly same as standard Page Program. (Please refer to Figure 7-

24 and Figure 7-25).

AT25QL321-DWF 数据表(PDF) 30 Page - Dialog Semiconductor