MWPR1024IZVHT datasheet(21/86 Pages) NXP

21 / 86 page

Table 4. Top Level Receiver Specifications (TA=25°C, nominal process unless otherwise

noted) (continued)

Characteristic1

Symbol

Min.

Typ.

Max.

Unit

Bluetooth LE Adjacent +/- 2 MHz Interference offset

(Wanted signal at -67 dBm , BER <0.1%. Measurement

resolution 1 MHz.)

SELBluetooth LE, 2 MHz

—

Bluetooth LE Alternate ≥ +/-3 MHz Interference offset

(Wanted signal at -67 dBm, BER <0.1%. Measurement

resolution 1 MHz.)

SELBluetooth LE, 3 MHz

—

Intermodulation Performance

Bluetooth LE Intermodulation with continuous wave

interferer at ± 3MHz and modulated interferer is at ±

6MHz (Wanted signal at -67 dBm , BER<0.1%.)

—

-42

—

dBm

Bluetooth LE Intermodulation with continuous wave

interferer at ±5MHz and modulated interferer is at

±10MHz (Wanted signal at -67 dBm , BER<0.1%.)

—

-35

—

dBm

Blocking Performance6

Bluetooth LE Out of band blocking from 30 MHz to 1000

MHz and 4000 MHz to 5000 MHz (Wanted signal at -67

dBm , BER<0.1%. Interferer continuous wave signal.)7

—

-5

—

dBm

Bluetooth LE Out of band blocking from 1000 MHz to

2000 MHz and 3000 MHz to 4000MHz (Wanted signal

at -67 dBm , BER<0.1%. Interferer continuous wave

signal.)

—

-12

—

dBm

Bluetooth LE Out of band blocking from 2001 MHz to

2339MHz and 2484 MHz to 2999 MHz (Wanted signal

at -67 dBm , BER<0.1%. Interferer continuous wave

signal.)

—

-20

—

dBm

Bluetooth LE Out of band blocking from 5000 MHz to

12750 MHz (Wanted signal at -67 dBm , BER<0.1%.

Interferer continuous wave signal.)7

—

dBm

Spurious Emission < 1.6 MHz offset (Measured with

100 kHz resolution and average detector. Device

transmit on RF channel with center frequency fc and

spurious power measured in 1 MHz at RF frequency f),

where |f-fc|< 1.6 MHz

—

-54

—

dBc

Spurious Emission > 2.5 MHz offset (Measured with

100 kHz resolution and average detector. Device

transmit on RF channel with center frequency fc and

spurious power measured in 1 MHz at RF frequency f),

where |f-fc|> 2.5 MHz8

—

-70

—

dBc

1. All the RX parameters are measured at the MWPR1x24 RF pins

2. Transceiver power consumption

3. Measured at 0.1% BER using 37 byte long packets in max gain mode and nominal conditions

4. RSSI performance in narrowband mode

5. With one point calibration over frequency and temperature

6. Bluetooth LE Adjacent and Block parameters are measured with modulated interference signals

7. Exceptions allowed for carrier frequency harmonics.

8. Exceptions allowed for twice the reference clock frequency(fref) multiples.

Transceiver Electrical Characteristics

MWPR1124ZVHT/MWPR1024IZVHT Data Sheet, Rev. 0, 04/2018

NXP Semiconductors

MWPR1024IZVHT 数据表(PDF) 21 Page - NXP Semiconductors

MWPR1024IZVHT 数据表(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

数据表下载