–

–

–

–

12

13

The Development Kit Demonstration Software

The development kit includes software that is used to configure and control

the module through the Programming Dock. The software defaults to the

Demo & EZConfiguration tab when opened (Figure 13). This window offers

basic configuration and demonstration of the module’s functionality with the

current configuration.

1. Clicking the Contact Linx, Documentation and About labels on the

left side expands them to show additional information and links to the

latest documentation. This is shown in Figure 15.

2. The Help window shows tips and comments about the software.

3. The active module is connected to the PC and being configured by the

software.

4. Available modules are connected to the PC but are not currently being

configured or controlled by the PC

5. Known Modules are not currently connected to the PC, but have either

been connected to the software in the past or have been manually

entered.

6. The Given Permissions window shows the list of modules that are

paired with the active module and the Permissions Mask for each one.

7. The demo area replicates a remote control device. The appearance

changes with the programmed configurations.

7

4

1

2

3

10

6

8

11

5

9

Figure 13: The Master Development System Software Demo and EZConfiguration Tab

Module to Prototype Board Pin Number Cross Reference

Pin Name

Module Pin Number

Prototype Board Pin Number

MODE_IND

35

7

RESET

16

8

CMD_DATA_IN

27

9

POWER_DOWN

24

10

LATCH_EN

15

11

ACK_EN

36

13

PAIR

33

14

CMD_DATA_OUT

29

15

VCC

25

17

LVL_ADJ

14

18

C0

30

19

C1

32

21

RSSI

21

25

S0

9

38

S1

10

39

S2

12

40

S3

13

41

S4

20

42

S5

26

43

S6

19

44

S7

18

45

ACK_OUT

31

46

Figure 12: Module to Prototype Board Pin Number Cross Reference

The overload condition is reset once the excess current draw is removed.

The LADJ line has pads for both a pull up and pull down resistor. This can

be populated based on the needs of the specific module that is connected

to the prototype board. The TT Series uses the pull-down resistor. Do

not populate both resistors at the same time as this results in a direct

connection between power and ground.

Figure 12 shows a convenient cross reference showing which lines on the

module connect to which lines on the prototype board.