–

–

–

–

22

23

7. The Pairing Status area shows the current status of any pairing

operations.

8. The request Remote Sample configures the module to request a

response from a remote unit. This area configures the type of sample

that should be in the response and the address of the unit that should

respond.

9. The Read All button reads all of the current configurations from the

active module.

10. The Submit button writes all changes to the active module.

11. The Set Defaults button restores the active module to factory default

conditions.

12. The Commit button writes any changed configurations to non-volatile

memory. The changes should be written to the module using the

Submit button first, then the Commit button is used to make the

changes permanent.

Development Kit Demonstration Software Example

This example shows how to configure two modules to work with each

other. The software defaults to the Demo & EZConfiguration tab when

opened (Figure 22).

Install Carrier Boards onto the Programming Docks and plug a USB cable

between the Programming Docks and the PC. The software automatically

detects attached devices. The first module that is identified appears

under the Active label. This is the module that is actively controlled by

the software. Subsequent modules are listed under the Available label as

shown in Figure 23.

Modules must be paired with the active device. This is accomplished by

dragging modules from the Available or Known Modules lists to the Given

Permissions window as shown in Figure 24.

Figure 22: The Master Development System Software Demo and EZConfiguration Tab

Figure 23: The Master Development System Software Connected Modules