AS5600-ASOT datasheet(20/44 Pages) OSRAM

20 / 44 page

ams Datasheet

Page 19

[v1-06] 2018-Jun-20

Document Feedback

AS5600 − Register Description

ZPOS/MPOS/MANG Registers

These registers are used to configure the start position (ZPOS)

and a stop position (MPOS) or maximum angle (MANG) for a

narrower angular range. The angular range must be greater

than 18 degrees. In case of narrowed angular range, the

resolution is not scaled to narrowed range (e.g. 0° to

360°(full-turn)

→ 4096dec; 0° to180°→2048dec). To configure

the angular range, see Angle Programming.

CONF Register

The CONF register supports customizing the AS5600. Figure 22

shows the mapping of the CONF register.

Figure 22:

CONF Register

Note(s):

1. Forced in Low Power Mode (LPM)

ANGLE/RAW ANGLE Register

The RAW ANGLE register contains the unscaled and unmodified

angle. The scaled output value is available in the ANGLE register.

Note(s): The ANGLE register has a 10-LSB hysteresis at the limit

of the 360 degree range to avoid discontinuity points or

toggling of the output within one rotation.

Name

Bit Position

Description

PM(1:0)

1:0

Power Mode

00 = NOM, 01 = LPM1, 10 = LPM2, 11 = LPM3

HYST(1:0)

3:2

Hysteresis

00 = OFF, 01 = 1 LSB, 10 = 2 LSBs, 11 = 3 LSBs

OUTS(1:0)

5:4

Output Stage

00 = analog (full range from 0% to 100% between GND and VDD, 01 = analog

(reduced range from 10% to 90% between GND and VDD, 10 = digital PWM

PWMF

(1:0)

7:6

PWM Frequency

00 = 115 Hz; 01 = 230 Hz; 10 = 460 Hz; 11 = 920 Hz

SF(1:0)

9:8

Slow Filter

00 = 16x (1); 01 = 8x; 10 = 4x; 11 = 2x

FTH(2:0)

12:10

Fast Filter Threshold

000 = slow filter only, 001 = 6 LSBs, 010 = 7 LSBs, 011 = 9 LSBs,100 = 18 LSBs, 101

= 21 LSBs, 110 = 24 LSBs, 111 = 10 LSBs

Watchdog

0 = OFF, 1 = ON

AS5600-ASOT 数据表(PDF) 20 Page - OSRAM GmbH

AS5600-ASOT 数据表(HTML) 20 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载