ICS853S024AY REVISION A JULY 20, 2011

13

©2011 Integrated Device Technology, Inc.

ICS853S024 Data Sheet

LOW SKEW, 1-TO-24, DIFFERENTIAL-TO-3.3V, 2.5V LVPECL FANOUT BUFFER

EPAD Thermal Release Path

In order to maximize both the removal of heat from the package and

the electrical performance, a land pattern must be incorporated on

the Printed Circuit Board (PCB) within the footprint of the package

corresponding to the exposed metal pad or exposed heat slug on the

package, as shown in Figure 6. The solderable area on the PCB, as

defined by the solder mask, should be at least the same size/shape

as the exposed pad/slug area on the package to maximize the

thermal/electrical performance. Sufficient clearance should be

designed on the PCB between the outer edges of the land pattern

and the inner edges of pad pattern for the leads to avoid any shorts.

While the land pattern on the PCB provides a means of heat transfer

and electrical grounding from the package to the board through a

solder joint, thermal vias are necessary to effectively conduct from

the surface of the PCB to the ground plane(s). The land pattern must

be connected to ground through these vias. The vias act as “heat

pipes”. The number of vias (i.e. “heat pipes”) are application specific

and dependent upon the package power dissipation as well as

electrical conductivity requirements. Thus, thermal and electrical

analysis and/or testing are recommended to determine the minimum

number needed. Maximum thermal and electrical performance is

achieved when an array of vias is incorporated in the land pattern. It

is recommended to use as many vias connected to ground as

possible. It is also recommended that the via diameter should be 12

to 13mils (0.30 to 0.33mm) with 1oz copper via barrel plating. This is

desirable to avoid any solder wicking inside the via during the

soldering process which may result in voids in solder between the

exposed pad/slug and the thermal land. Precautions should be taken

to eliminate any solder voids between the exposed heat slug and the

land pattern. Note: These recommendations are to be used as a

guideline only. For further information, refer to the Application Note

on the Surface Mount Assembly of Amkor’s Thermally/Electrically

Enhance Leadframe Base Package, Amkor Technology.

Figure 6. Assembly for Exposed Pad Thermal Release Path - Side View (drawing not to scale)

GROUND PLANE

LAND PATTERN

SOLDER

THERMAL VIA

EXPOSED HEAT SLUG

(GROUND PAD)

PIN

PIN PAD

SOLDER

PIN

PIN PAD

SOLDER