Document Feedback

TMF882X

Using the EVM Software

Demo Kit Manual

• PUBLIC

UG000495

• v6-00 • 2022-May-19

36

│ 26

3.6.2

Automation Interface Reference

These commands are simple strings the remote control programs sends to the GUI via the TCP/IP

connection. The GUI sends the command response back to the remote control program over the same

connection (socket).

Each command starts with an opening parenthesis "(". The GUI executes the command after the

remote control sends a closing parenthesis ")".

The first character in the command (after the opening parenthesis) is the command code. All

characters after that are the command parameter (until the closing parenthesis). Command codes are

case-insensitive.

e.g.: (I1000) sets the "Iterations [k]" spin box in the GUI to the value 1000.

Set Iterations

Sets the number of ToF measurement iterations ("Iterations [k]" spin box).

Figure 22:

Command Overview

Command Code

Parameter

Example

I

Number of iterations,

0 <= iterations <= 65535

(I1000)

Set Object Detection Threshold

Sets the object detection threshold ("Threshold" spin box).

Figure 23:

Command Overview

Command Code

Parameter

Example

T

Object detection threshold,

0 <= threshold <= 255

(T128)

Run Measurement

Run one GUI measurement and send the results to the remote control program via the TCP/IP

connection.