ADN2813 datasheet(13/28 Pages) AD

13 / 28 page

ADN2813

Rev. 0 | Page 13 of 28

JITTER SPECIFICATIONS

The ADN2813 CDR is designed to achieve the best bit-

error-rate (BER) performance and to exceed the jitter

transfer, generation, and tolerance specifications proposed

for SONET/SDH equipment defined in the Telcordia

Technologies specification.

Jitter is the dynamic displacement of digital signal edges from

their long-term average positions, measured in unit intervals

(UI), where 1 UI = 1 bit period. Jitter on the input data can

cause dynamic phase errors on the recovered clock sampling

edge. Jitter on the recovered clock causes jitter on the

retimed data.

The following sections briefly summarize the specifications of

jitter generation, transfer, and tolerance in accordance with the

Telcordia document (GR-253-CORE, Issue 3, September 2000)

for the optical interface at the equipment level and the ADN2813

performance with respect to those specifications.

Jitter Generation

The jitter generation specification limits the amount of jitter

that can be generated by the device with no jitter and wander

applied at the input. For SONET devices, the jitter generated

must be less than 0.01 UI rms and must be less than 0.1 UI p-p.

Jitter Transfer

The jitter transfer function is the ratio of the jitter on the output

signal to the jitter applied on the input signal vs. the frequency.

This parameter measures the limited amount of the jitter on an

input signal that can be transferred to the output signal (see

Figure 15).

0.1

ACCEPTABLE

RANGE

JITTER FREQUENCY (kHz)

SLOPE = –20dB/DECADE

Figure 15. Jitter Transfer Curve

Jitter Tolerance

The jitter tolerance is defined as the peak-to-peak amplitude of

the sinusoidal jitter applied on the input signal, which causes a

1 dB power penalty. This is a stress test intended to ensure that

no additional penalty is incurred under the operating conditions

(see Figure 16).

15.00

1.50

0.15

JITTER FREQUENCY (kHz)

SLOPE = –20dB/DECADE

Figure 16. SONET Jitter Tolerance Mask

ADN2813 数据表(PDF) 13 Page - Analog Devices

ADN2813 数据表(HTML) 13 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载