AD8336ACPZ-R7 datasheet(24/28 Pages) AD

24 / 28 page

AD8336

Rev. 0 | Page 24 of 28

Circuit Configuration for Inverting Gain

The preamplifier can also be used in an inverting configuration,

as shown in Figure 81.

PRAO

34dB

AD8336

PREAMPLIFIER

INPP

–

GAIN = 9.6dB INPN

CIRCUIT CONFIGURATION FOR INVERTING GAIN

RFB1

100Ω

RFB2

301Ω

VPOS

VNEG

VOUT

+5V

–5V

PWRA

VCOM

–60dB TO 0dB

Figure 81. Circuit Configuration for Inverting Gain

The same considerations regarding total resistance vs. distortion,

noise, and power as noted in the noninverting case apply, except

that the amplifier can be operated at unity inverting gain. The

signal gain is reduced while the noise gain is the same as for the

noninverting configuration:

Gain

Signal

and

Gain

Noise

USING THE POWER ADJUST FEATURE

The AD8336 has the provision to operate at lower power with

a trade-off in bandwidth. The power reduction applies to the

preamp and the VGA sections, and the bandwidth is reduced

equally between them. Reducing the power is particularly useful

when operating with higher supply voltages and lower values of

output loading that would otherwise stress the output amplifiers.

When Pin PWRA is grounded, the amplifiers operate in their

default mode, and the combined 3 dB bandwidth is 80 MHz

with the preamp gain adjusted to 4×. When the voltage on

Pin PWRA is between 1.2 V and 5 V, the power is reduced by

approximately half and the 3 dB bandwidth reduces to

approximately 35 MHz. The voltage at pin PWRA must not

exceed 5 V.

DRIVING CAPACITIVE LOADS

The output stages of the AD8336 are stable with capacitive loads

up to 47 pF for a supply voltage of ±3 V, and capacitive loads up

to 10 pF for supply voltages up to ±8 V. For larger combined

values of load capacitance and/or supply voltage, a 20 Ω series

resistor is recommended for stability.

The influence of capacitance and supply voltage are shown in,

Figure 50 and Figure 51, where representative combinations of

load capacitance and supply voltage requiring a 20 Ω resistor

are marked with an asterisk. No resistor is required for the ±3 V

plots in Figure 49, while a resistor is required for most of the

±12 V plots in Figure 51.

AD8336ACPZ-R7 数据表(PDF) 24 Page - Analog Devices

AD8336ACPZ-R7 数据表(HTML) 24 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载