The information contained herein is exclusive property of. Do not copy and print except that Attend accepts.

本文件係屬立威科技股份有限公司所有；非經同意，不得以任何覆寫、拷貝、翻印等方式私自據有。亦不得擅加毀損、塗改。

-2 -

maximum at open circuit voltage of

20mV (max).

(JIS C5402 5.4)

Insulation Resistance

Initial: 500Ω Min.

After: 100MΩ Min.

Apply 500V DC between adjacent

contacts, or contact and ground.

(MIL-STD-202 METHOD 302)

Dielectric Withstanding

Voltage

No breakdown

Mate connectors; apply 250V AC at

60Hz (rms.) between two adjacent for 1

minute. (Trip current:0.5mA)

(MIL-STD-202 METHOD 301)

MECHANICAL

Item

Requirement

Test Condition

Contact Normal Force

50gf per pin Min.

The normal force of the individual

contact shall be 50 gf minimum

Contact Retention Force

180gf per pin Min.

Place a connector on the push-pull

machine, then apply a force on a

contact head and push the contact to

the opposite direction of the contact

insertion at the speed of 25±3mm/min.

(EIA364-29)

Durability

Finish

1.Contact Resistance:

50mΩ Max.

2.No Damage

After 50 mating and un-mating cycles

with 1.0mm thick board at the rate of

25±3mm/min.

The connector shall be of no damage to

the housing or contacts. The connector

shall also meet the requirements of

contact resistance in the paragraph 5.1

(EIA364-09)

Shock

Finish

1. No electrical discontinuity

more than 0.1μs.

2 .No Damage

3. Contact Resistance: 50mΩ

Max.

Solder connectors on PCB and mate

them together, subject to following

shock conditions, 3 shocks shall be

period along 3 mutually perpendicular

axis, passing DC 1mA current during

the test.

50G,11ms Half-sine