32G431 datasheet(21/198 Pages) STMICROELECTRONICS

21 / 198 page

DS12589 Rev 6

21/198

STM32G431x6 STM32G431x8 STM32G431xB

Functional overview

FMAC features

•

16 x 16-bit multiplier

•

24+2-bit accumulator with addition and subtraction

•

16-bit input and output data

•

256 x 16-bit local memory

•

Up to three areas can be defined in memory for data buffers (two input, one output),

defined by programmable base address pointers and associated size registers

•

Input and output sample buffers can be circular

•

Buffer “watermark” feature reduces overhead in interrupt mode

•

Filter functions: FIR, IIR (direct form 1)

•

AHB slave interface

•

DMA read and write data channels

3.10

Cyclic redundancy check calculation unit (CRC)

The CRC (cyclic redundancy check) calculation unit is used to get a CRC code using a

configurable generator with polynomial value and size.

Among other applications, the CRC-based techniques are used to verify data transmission

or storage integrity. In the scope of the EN/IEC 60335-1 standard, they offer a mean to verify

the Flash memory integrity.

The CRC calculation unit helps to compute a signature of the software during runtime, which

can be ulteriorly compared with a reference signature generated at link-time and which can

be stored at a given memory location.

3.11

Power supply management

3.11.1

Power supply schemes

The STM32G431x6/x8/xB devices require a 1.71 V to 3.6 V VDD operating voltage supply.

Several independent supplies, can be provided for specific peripherals:

•

VDD = 1.71 V to 3.6 V

VDD is the external power supply for the I/Os, the internal regulator and the system

analog such as reset, power management and internal clocks. It is provided externally

through the VDD pins.

•

VDDA = 1.62 V to 3.6 V (see Section 5: Electrical characteristics for the minimum VDDA

voltage required for ADC, DAC, COMP, OPAMP, VREFBUF operation).

VDDA is the external analog power supply for A/D converters, D/A converters, voltage

reference buffer, operational amplifiers and comparators. The VDDA voltage level is

independent from the VDD voltage and should preferably be connected to VDD when

these peripherals are not used.

•

VBAT = 1.55 V to 3.6 V

VBAT is the power supply for RTC, external clock 32 kHz oscillator and backup registers

(through power switch) when VDD is not present.

32G431 数据表(PDF) 21 Page - STMicroelectronics

32G431 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载