Production Data

WM8766

w

PD Rev 4.1 July 2005

13

System Clock Frequency (MHz)

SAMPLING

RATE

(LRCLK)

128fs

192fs

256fs

384fs

512fs

768fs

32kHz

4.096

6.144

8.192

12.288

16.384

24.576

44.1kHz

5.6448

8.467

11.2896

16.9340

22.5792

33.8688

48kHz

6.144

9.216

12.288

18.432

24.576

36.864

96kHz

12.288

18.432

24.576

36.864

Unavailable Unavailable

192kHz

24.576

36.864

Unavailable Unavailable Unavailable Unavailable

Table 6 System Clock Frequencies Versus Sampling Rate

HARDWARE CONTROL MODES

When the MODE pin is held high, the following hardware modes of operation are available.

MUTE AND AUTOMUTE OPERATION

In both hardware and software modes, MUTE controls the selection of MUTE directly, and can be

used to enable and disable the automute function. This pin becomes an output when left floating and

indicates infinite ZERO detect (IZD) has been detected.

DESCRIPTION

0

Normal Operation

1

Mute DAC channels

Floating

Enable IZD, MUTE becomes an output to indicate when IZD occurs.

L=IZD not detected, H=IZD detected.

Table 7 Mute and Automute Control

Figure 9 shows the application and release of MUTE whilst a full amplitude sinusoid is being played

at 48kHz sampling rate. When MUTE (lower trace) is asserted, the output (upper trace) begins to

with a time constant of approximately 64 input samples. When MUTE is de-asserted, the output will

restart almost immediately from the current input sample.

Figure 9 Application and Release of Soft Mute

-2.5

-2

-1.5

-1

-0.5

0

0.5

1

1.5

0

0.001

0.002

0.003

0.004

0.005

0.006

Time(s)