AM263P4 datasheet(42/154 Pages) TI

42 / 154 page

5.3 Signal Descriptions

Many signals are available on multiple pins, according to the software configuration of the pin multiplexing

options.

The following list describes the column headers:

1. SIGNAL NAME: The name of the signal passing through the pin.

Note

Signal names and descriptions provided in each Signal Descriptions table, represent the pin

multiplexed signal function which is implemented at the pin and selected via IOMUX pad

configuration registers. Some device subsystems provide secondary multiplexing of signal

functions, which are not described in these tables. For more information on secondary multiplexed

signal functions, see the respective peripheral chapter of the device TRM.

2. PIN TYPE: Signal direction and type:

• I = Input

• O = Output

• IO = Input, Output, or simultaneously Input and Output

• ID = Input with open-drain output function

• OD = Output, with open-drain output function

• IOD = Input, Output, or simultaneously Input and Output, with open-drain output function

• IOZ = Input, Output, or simultaneously Input and Output, with three-state output function

• OZ = Output with three-state output function

• A = Analog

• CAP = LDO capacitor

• PWR = Power

• GND = Ground

3. DESCRIPTION: Description of the signal

4. BALL: Associated ball number

For more information on the I/O cell configurations, see the Pad Configuration Registers section within the

Device Configuration chapter of the device TRM.

TI Information - Selective Disclosure

AM263P4, AM263P2, AM263P1, AM263P4-Q1, AM263P2-Q1, AM263P1-Q1

SPRSP81 – OCTOBER 2023

www.ti.com

Submit Document Feedback

AM263P4 数据表(PDF) 42 Page - Texas Instruments