TUSB211A-Q1 Automotive USB 2.0 480Mbps High-Speed Signal Conditioner

1 Features

• AEC-Q100 qualified for automotive applications

– Device temperature grade 2: -40°C to 105°C

• Wide supply voltage range: 2.3 – 6.5V

• Ultra-low USB disconnect and shutdown power

consumption

• Provides USB 2.0 high-speed signal conditioning

• Compatible with USB 2.0, OTG 2.0, and BC 1.2

• Support for low-speed, full-speed, and high-speed

signaling

• Host or device agnostic

• Supports up to 5m cable length

– Four selectable signal EQ (edge boost along

with DC boost) settings through the external

pull-down resistor values

• Supports up to 10m cable length with two

TUSB211A-Q1 devices

• Scalable solution – devices can be daisy chained

for high loss applications

• Pin compatible with TUSB211, 212, 214, 216, and

217A (3.3V)

2 Applications

• Automotive infotainment and cluster

• Automotive head unit

• Active cable, cable extenders, and backplane

D2

D1

Cable

USB

Connector

VCC

GND

USB

Host

2.3V – 6.5V

Simplified Schematic

3 Description

The TUSB211A-Q1 is a third-generation USB™

2.0 high-speed signal conditioner designed to

compensate both AC loss (due to capacitive load) and

DC loss (due to resistive loss) in the transmission

channel.

The TUSB211A-Q1 leverages a patented design to

speed-up transition edges of USB 2.0 high-speed

signal with an edge booster and increases static

levels with a DC boost function.

In addition, the TUSB211A-Q1 includes a pre-

equalization function to compensate the inter-symbol

interference (ISI) jitter in application with longer

cable length. USB low-speed and full-speed signal

characteristics are unaffected by the TUSB211A-Q1.

The TUSB211A-Q1 improves signal quality without

altering packet timing or adding propagation delay or

latency.

The TUSB211A-Q1 helps a system to pass the USB

2.0 high-speed near end eye compliance with a cable

as long as 5 meters.

The TUSB211A-Q1 is compatible with USB On-The-

Go (OTG) and Battery Charging (BC) protocols.

Device Comparison

PART NUMBER

PACKAGE(1)

OP TEMP (TA) °C

TUSB211A

RWB (X2QFN, 12)

0 to 70

TUSB211AI

-40 to 85

TUSB211A-Q1

-40 to 105

Package Information

PART NUMBER

PACKAGE(1)

PACKAGE SIZE(2)

TUSB211A-Q1

RWB (X2QFN, 12)

1.6mm × 1.6mm

(1)

For more information, see Section 10.

(2)

The package size (length × width) is a nominal value and

includes pins, where applicable.

TUSB211A-Q1

SLLSFX8 – FEBRUARY 2024

An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,

intellectual property matters and other important disclaimers. PRODUCTION DATA.