PCF8578USLASH2 datasheet(21/44 Pages) PHILIPS

21 / 44 page

1998 Sep 08

Philips Semiconductors

Product speciﬁcation

LCD row/column driver for dot matrix

graphic displays

PCF8578

8.1

Command decoder

The command decoder identifies command bytes that

arrive on the I2C-bus. The most-significant bit of a

command is the continuation bit C (see Fig.14). When this

bit is set, it indicates that the next byte to be transferred will

also be a command. If the bit is reset, it indicates the

conclusion of the command transfer. Further bytes will be

regarded as display data. Commands are transferred in

WRITE mode only.

The five commands available to the PCF8578 are defined

in Tables 5 and 6.

Fig.14 General information of command byte.

MSA833

REST OF OPCODE

MSB

LSB

C = 0; last command.

C = 1; commands continue.

Table 5

Summary of commands

Note

1. C = command continuation bit. D = may be a logic 1 or 0.

COMMAND

OPCODE(1)

DESCRIPTION

SET MODE

DDDDD

multiplex rate, display status, system type

SET START BANK

11111

deﬁnes bank at top of LCD

DEVICE SELECT

DDDD

deﬁnes device subaddress

RAM ACCESS

DDDD

graphic mode, bank select (D D D D

≥ 12 is not

allowed; see SET START BANK opcode)

LOAD X-ADDRESS

DDDDD

0 to 39

PCF8578U/2 数据表(PDF) 21 Page - NXP Semiconductors

PCF8578U/2 数据表(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载