SP5T PIN Diode Reflective Switch

MA4SW510

V 2.00

M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s)

or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

2

Note: Typical Switching Speed measured from 10 % to 90 % of detected RF signal driven by a TTL compatible driver.

(On-Wafer Measurements)

Parameters

Frequency

Minimum

Typical

Maximum

Units

Insertion Loss

20 GHz

-

0.9

1.4

dB

Isolation

20 GHz

28

38

-

dB

Input Return Loss

20 GHz

-

22

-

dB

20 GHz

-

23

-

dB

Switching Speed

1

10 GHz

-

50

-

nS

Output Return Loss

Control Level (DC Current)

J2

J3

J4

J5

J2-J1

J3-J1

J4-J1

J5-J1

-20 mA +20 mA +20 mA +20 mA

Low Loss

Isolation

Isolation

Isolation

+20 mA -20 mA +20 mA +20 mA

Isolation

Low Loss

Isolation

Isolation

+20 mA +20 mA -20 mA +20 mA

Isolation

Isolation

Low Loss

Isolation

+20 mA +20 mA +20 mA -20 mA

Isolation

Isolation

Isolation

Low Loss

Condition of RF Output

J6

+20 mA

+20 mA

+20 mA

-20 mA

+20 mA +20 mA +20 mA +20 mA -20 mA

Isolation

Isolation

Isolation

Isolation

J6-J1

Isolation

Isolation

Isolation

Isolation

Low Loss

Typical Driver Connections

1. Typical switching speed is measured from 10% to 90% of the detected RF voltage driven by a TTL compatible driver. Driver

output parallel RC network uses a capacitor between 390 pF - 560 pF and a resistor between 150 - 220 Ohms to achieve

50 ns rise and fall times.