9 / 10 page
4-219
RF2314
Rev A6 051025
PCB Design Requirements
PCB Surface Finish
The PCB surface finish used for RFMD’s qualification process is Electroless Nickel, immersion Gold. Typical thickness is
3
μinch to 8μinch Gold over 180μinch Nickel.
PCB Land Pattern Recommendation
PCB land patterns are based on IPC-SM-782 standards when possible. The pad pattern shown has been developed and
tested for optimized assembly at RFMD; however, it may require some modifications to address company specific
assembly processes. The PCB land pattern has been developed to accommodate lead and package tolerances.
PCB Metal Land Pattern
PCB Solder Mask Pattern
Liquid Photo-Imageable (LPI) solder mask is recommended. The solder mask footprint will match what is shown for the
PCB metal land pattern with a 3mil expansion to accommodate solder mask registration clearance around all pads. The
center-grounding pad shall also have a solder mask clearance. Expansion of the pads to create solder mask clearance
can be provided in the master data or requested from the PCB fabrication supplier.
A = 0.70 x 1.00 (mm) Typ.
Pin 1
Pin 5
A
A
A
A
A
0.95 (mm)
Typ.
1.90 (mm)
Typ.
2.60 (mm)
Figure 1. PCB Metal Land Pattern (Top View)
A = 0.90 x 1.20 (mm) Typ.
0.95 (mm)
Typ.
1.90 (mm)
Typ.
2.60 (mm)
A
A
A
A
A
Figure 2. PCB Solder Mask Pattern (Top View)
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
