4 / 14 page
11-42
RF2514
Rev A5 040115
Pin
Function
Description
Interface Schematic
13
LD FLT
This pin is used to set the threshold of the lock detect circuit. A shunt
capacitor should be used to set an RC time constant with the on-chip
series 1k resistor. The time constant should be approximately 10 times
the reference period.
14
DIV CTRL
Logic “High” input selects divide-by-64 prescaler. Logic “Low” input
selects divide-by-32 prescaler.s
15
OSC B
This pin is connected directly to the reference oscillator transistor base.
The intended reference oscillator configuration is a modified Colpitts. A
68pF capacitor should be connected between pin 15 and pin 16.
16
OSC E
This pin is connected directly to the emitter of the reference oscillator
transistor. A 33pF capacitor should be connected from this pin to
ground.
See pin 15.
Die
Flag
GND
Exposed die flag is centered and measures 1.5mmx1.5mm
(0.059in.x0.059in.). For best results, provide a solder pad for the flag
and connect immediately to ground plane (see evaluation board lay-
out). Internally connected to pins 1 and 9.
ESD
This diode structure is used to provide electrostatic discharge protec-
tion to 3kV using the Human body model. The following pins are pro-
tected: 1, 2, 4-9, 12-14. The die flag is not protected.
LD FLT
V
CC
DIV CTRL
V
CC
OSC E
V
CC
OSC B
V
CC
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
